- Contains silver that may help inhibit the growth of microorganisms within the dressing
- Water-based gel wound dressing
- OTC use in the topical management of minor cuts, lacerations, abrasions, skin irritations, sunburns, and 1st and 2nd degree burns
- Use by or on the order of a licensed healthcare Practitioner for wounds such as stasis ulcers, pressure ulcers, diabetic ulcers, skin tears, surgical incision sites, device insertion site wounds, graft sites, and donor sites
- Chloride free
- Unscented – Fragrance free
- Designed for use in moist wound care management
- May inhibit growth of microorganisms within wound dressing
- FDA cleared
- Medicare Part B Reimbursement
- HCPC Reimbursement #A6248
SilvrSTAT® Antibacterial Wound Dressing Gel contains silver that in laboratory tests has been shown to inhibit the growth of microorganisms including: Staphylococcus aureus, Pseudomonas aeruginosa, E. coli, MRSA and VRE, as well as fungi such as Candida albicans.
*Results of in-vitro kill rate tests indicated that SilvrSTAT was effective against the tested micro-organisms, Methicillin-Resistant Staphylococcus aureus (MRSA), Escherichia coli (E. coli), Staphylococcus aureus, Pseudomonas aeruginosa, and Candida albicans. Correlation between laboratory testing and reduced risk of infection has not been established.
Main Ingredient: 32 PPM Proprietary Silver (Purified Water, Patented Nano-Silver Technology at .01 Micron).
Other Ingredients: Propylene Glycol, Triethanolamine, Carbomer.
Directions for use under the supervision of a licensed healthcare practitioner: SilvrSTAT® Antibacterial Wound Dressing Gel should be applied directly to the wound, and then covered with a conventional dressing. SilvrSTAT® Antibacterial Would Dressing Gel should normally be changed every 24-72 hours, but the frequency will depend on the type and condition of the wound.
Directions for OTC use (not under the care of a licensed healthcare practitioner):
1) Wash your hands with soap and water before touching the wound.
2) Carefully clean the wound using soap and water or an appropriate commercial brand of wound cleanser.
3) Dispense SilvrSTAT® onto an appropriate clean applicator (such as a tongue depressor or gauze) in a sufficient amount to liberally cover the wound. Cover the gel with appropriate secondary dressing cover such as a gauze bolster, dressing wrap, film or non-woven adhesive secondary dressing.
Changing the Dressing:
1) Carefully remove the secondary dressing from the wound.
2) Residual SilvrSTAT® may be removed with the cover dressing. 3) Follow instructions above to re-apply the gel.
Frequency of Change:
SilvrSTAT® gel should normally be changed every 24-72 hours, but the frequency will depend on the type and condition of the wound.
Consult with a healthcare professional if you have any concerns or questions about the wound. Be alert for signs of wound infection. These can include: pus or cloudy fluid draining from the wound, increased redness around the wound, wound has become extremely tender, increased pain or swelling 48 hours after the wound occurred, onset of fever, and wound has not healed within 10 days from the date of the injury. SilvrSTAT® is designed for use on any part of the body except for oral and ophthalmic use. Consult a healthcare practitioner before using the gel in any other manner.
Intended for external use only. If your condition persists or gets worse, contact your healthcare provider.
There are no known or reasonably suspected adverse reactions associated with the use of SilvrSTAT® Antibacterial Wound Dressing Gel.
Store at room temperature.
CAUTION: Federal law restricts this device to sale by or on the order of a licensed healthcare practitioner if it is used to treat the following: wounds such as stasis ulcers, pressure ulcers, diabetic ulcers, surgical incision sites, device insertion site wounds, skin tears, graft sites and donor sites.